Introduction

Hardware Design Development Training makes you an expert in using a Microcontroller Surge protection circuits, EMI/EMC protections, Interfacings, Current source, Amplifiers, Opamps, Logic Gates, Flip flops, and Counters ….etc

Course Content

1.Introduction

• Introduction to Hardware design & development process
• Introduction to analog and digital design world (brief about analog and digital components)
• Active elements
• Passive elements
• Voltage source
• Current source
• Amplifiers
• Opamps
• Logic Gates
• Flip flops
• Counters.

2.Power Supply Design

• Primary supplies
• Secondary supplies
• Static supplies (without Feedback)
• Dynamic supplies (with Feedback)
• Linear supplies
• Switching supplies
• Current controlled supplies
• Voltage controlled supplies
• Over voltage protection
• Under voltage protection
• Over current current
• Current control methods
• Surge protection circuits
• EMI/EMC protections
• Mini projectPower supply design.

3.Microcontroller & Peripheral’s

• Different types of IC packages
• Identification of Controller
• Reset circuit
• Debugger circuit
• Push pull design of port pins
• Open drain design of port pins
• Memory Technologies (RAM, ROM, EPROM, EEPROM, FLASH) interfacing
• I/O Interface Technologies.

4.Communication Modules & User Interfaces

• Different types of communication modules and interfaces
  RS232, 485, 422 full duplex and half duplex, DMA, ADC, DAC, External Temperature
• External Watch RT dog
  ExternalC, TCP/IP, SPI, SSP, I2C, Wi-Fi, Bluetooth, USB, Zigbee, GPS, GPRS module, EDGE module.

5.Microcontroller Interfacings

• LEDs, Switches, Relays, DC Motor, Stepper Motor, ADC, DAC, Temperature Sensor, LCD, Touch Screen, Seven segment display… etc,
• Load calculations
• Power requirement calculation methods
• PCB mechanical fixing
• PCB dimension
• PCB external interface connectors
• Mini Project.

6.PCB Design And Manufacturing

• Types of PCB / Base Material
• Overview of PCB Technologies
• CAD System Selection
• Design Rules & Design Factors
• Component Selection and Identification
• Design Laminates / Thermal Management
• Reliability Tooling Holes / Stiffeners (IPCLessons), SMT, Wave and Reflow Soldering
• Layout Rules & Parameters / Library & Its Components,
• Cross Probing, Conductor routing / Mid Term Interaction.